Memorex RX 1 Smart Manual de instalación descargar pdf (Pagina 135)

134 | Simrad MX500

Autopilot Alarm:

Causes an alarm when your position is outside the cross-

track error limit defined in XTE Limit (above) or when you

change course to a new leg in your route (manually or

automatically passing a waypoint) when Yes is selected.

It also causes the NMEA data records of APA, APB, and

XTE to change their reported status of Valid to Invalid

when you reach the waypoint of the current leg. This tells

the autopilot not to use the data from the receiver.

When the alarm is canceled, which requires your high-

lighting of the Cancel Alarm softkey then press ENT

(displayed during the alarm condition), these data fields

will revert to valid data and the autopilot will accept the

receiver data again. This is provided as a safety feature

so that the boat does not turn toward a new direction

without your knowing of the impending change. To dis-

able the alarm, select No (the default condition) with the

Change softkey.

NMEA Out 1 and 2 - NMEA 0183 Output Data

Control

These screens set the specific NMEA 0183 output record

parameters as well as the port control. The default set-

ting is No. When this selection is changed to Yes, you can

turn on individual data records. Refer to the installation

manual of the device you interfaced with the receiver to

determine which output records are required. Refer to

the Installation section of this manual for receiver hard-

ware interface information.

MX500 Model - has two user NMEA ports available, two

antenna ports (NMEA3 & 4) dedicated to the MX smart

antenna, and one Local Area Network (LAN) port.

Pre plan your interface requirements to ensure all of your

interfacing needs are met. All NMEA Ports are RS-422

electrically. We recommend using these ports to interface

to a computer or other “single ended” interface.

The default condition of each port is Off. When you want

to output data on a NMEA port, scroll down the Item

menu to the appropriate NMEA Out port number and

change Port Active to Yes. In doing so, the receiver will

display all available NMEA 0183 output sentences.

1 2 ... 130 131 132 133 134 135 136 137 138 139 140 ... 261 262

Sin comentarios

Memorex RX 1 Smart Manual de instalación Pagina 135