Memorex RX 1 Smart Manual de instalación Pagina 229
- Pagina / 262
- Tabla de contenidos
- SOLUCIÓN DE PROBLEMAS
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
228 | Simrad MX500
Multiple Unit Control Conguration:
The Multiple Unit Control mode, which is enabled in
the CFG Dual Contrl. screen, allows you to connect
one MX500 as a Master, up to two MX500 as the Slave
units, and up to three MX500 as the Repeater units. The
Repeater unit, however, only acts as a display unit. It has
no capability to modify any setting unless a password
(set by the Master unit in CFG1/Security) is entered.
The Multiple Unit Control system must have a minimum
of three MX500 and a maximum of five MX500 units
altogether (see Table D-3). The system must have one
Master and at least one Slave. This allows a common
data base to be shared among the CDU control heads.
This configuration also allows you to use one antenna
connected to the Master unit for all CDUs. The remain-
ing data ports, the MOB/Event input port, and the alarm
output ports are still available on each unit for individual
use on each CDU.
The hardware interface is accomplished by connecting
the units together via an Ethernet switch. Refer to LAN
- Local Area Network in the Configuration section of this
manual to setup LAN.
No Antenna
Connected
MX 500
MASTER UNIT
MX 500
SLAVE UNIT
MX 422 Professional DGPS Navigator
MX 422 Professional DGPS Navigator
LAN Type: Host
LANType: Client
LAN Number: 1
Hub/Switch/Router
No Antenna
Connected
MX 500
SLAVE UNIT
MX 422 Professional DGP S Navigator
LAN Type: Client
LAN Number: 2
No Antenna
Connected
MX 500
SLAVE/REPEATER UNIT
MX 422 Professional DGPS Navigator
LAN Type: Client
LAN Number: 3
No Antenna
Connected
MX 500
SLAVE/REPEATER UNIT
MX 422 Professional DGP S Navigator
LAN Type: Client
CAT5
CAT5
CAT5
C
AT
5
C
A
T
5
- Simrad MX500 1
- Navigation System 1
- IMPORTANT NOTICE!! 3
- Symbols Used In This Manual 4
- Contents 6
- 6 7
- MX500 8
- 1 General 10
- About GPS Navigation 11
- Special Notes 12
- MX500 USB Feature Overview 13
- MX500 Networking Overview 13
- Simrad MX500 14
- Ethernet Switches: 15
- 2 Basic Operation 16
- MX500/DC (Dual Control) 17
- Monitoring) 17
- Simrad MX500 18
- 18 19
- DGPS Beacon System 20
- 20 21
- Red Flashing 22
- Red/Yellow Solid 22
- Red Solid 22
- Yellow/Green Solid 22
- GPS Trafc Light Operation: 23
- Yellow Solid 24
- Green Solid 24
- The Display: 25
- + Virtual Softkeys: 25
- The Function Keys: 26
- (MOB) Key 27
- POWER ON/OFF & LIGHT 28
- CLR (CLEAR) 29
- CURSOR 29
- FUNCTION 30
- Navigate 31
- Simrad MX500 32
- Dead Reckoning 33
- NAV1 - The Panorama Screen 33
- Simrad MX500 34
- 34 35
- Simrad MX500 36
- 36 37
- Simrad MX500 38
- 38 39
- Velocity Made Good: 40
- Waypoint Closure V elocity: 40
- NAV5 - Compass Display Screen 41
- NAV6 - Compass Display Screen 41
- Simrad MX500 42
- RTE1 - The Active Route 43
- Simrad MX500 44
- 44 45
- Simrad MX500 46
- 46 47
- Simrad MX500 48
- 48 49
- Choose in Bank 50
- 50 51
- Simrad MX500 52
- 52 53
- Maneuvering Within the Route 54
- 54 55
- Simrad MX500 56
- 56 57
- ETA Setup 58
- 58 59
- RTE2 - The Route Bank 60
- 60 61
- Waypoint 62
- 62 63
- Simrad MX500 64
- 64 65
- Simrad MX500 66
- Waypoint Lock/Unlock 67
- Simrad MX500 68
- 68 69
- Removing Waypoints 70
- 70 71
- Moving waypoints 72
- 72 73
- Rnn - Routes: 74
- RTE - Active Route: 74
- Standard: 75
- Simrad MX500 76
- Computer 77
- Simrad MX500 78
- Simrad MX500 80
- Mark or MOB 81
- Simrad MX500 82
- 82 83
- Simrad MX500 84
- 84 85
- PLOT 1 - Relative to Boat 86
- Customizing the Display 86
- 86 87
- Simrad MX500 88
- 88 89
- Man Over Board 90
- 90 91
- Auxiliary 92
- AUX1 - Alarm Log 92
- AUX2 - Speed Graph 93
- AUX4 - Sun Almanac 93
- AUX5 - Moon Phases 94
- AUX6 - Batteries 94
- AUX7 -Unit Information 95
- AUX 10 - Current Tide Display 96
- AUX 11 - Tide Table Port List 97
- Volume 1 98
- Volume 3 98
- Volume 2 98
- 6322-0 1A.600 98
- Adding a Port 99
- Position 100
- Latitude & Longitude 101
- User GRID 101
- & Time 102
- POS3 - Position & Log 102
- 102 103
- GPS1 - GPS Status Screen 104
- GPS2 - GPS Health Screen 105
- Models Only) 106
- 106 107
- GPS6 - DGPS STATUS 108
- 108 109
- Simrad MX500 110
- GPS7 - DGPS Messages 111
- 3 Advanced Operation 112
- Anchor - Anchor Watch Alarm 113
- Settings & Setup 113
- Magnetic Variation Table 114
- 114 115
- Depth - NMEA Input Control 116
- DGPS - DGPS Conguration 117
- Simrad MX500 118
- DR - Dead Reckoning 119
- Simrad MX500 120
- MX500 Dual Control Menu 120
- GPS - Elevation Mask Control 121
- LAN - Local Area Network 122
- Ty pe IP Address 123
- LORAN-C Integration 124
- Raytheon 124
- 124 125
- Simrad MX500 126
- 126 127
- Simrad MX500 128
- 128 129
- Simrad MX500 130
- Pass Criterion Control 131
- Simrad MX500 132
- 132 133
- Simrad MX500 134
- 134 135
- Simrad MX500 136
- MX500 NMEA Out Menu 136
- 136 137
- Simrad MX500 138
- 138 139
- Records: 140
- Settings 141
- Simrad MX500 142
- Alarm Control 143
- Simrad MX500 144
- 144 145
- Simrad MX500 146
- ROT (Rate of Turn) 147
- Security 148
- Serial I/O 148
- 148 149
- Simrad MX500 150
- 150 151
- Simrad MX500 152
- Blank page 153
- 4 Installation 154
- Simrad MX500 156
- (Front View) 156
- (Rear View) 156
- 156 157
- (Top and Side View) 157
- Simrad MX500 158
- Figure 4.4 Gimbal Mount 158
- 158 159
- 1 in.- 14 TPI 160
- 8-Pin Connector 160
- 160 161
- Simrad MX500 162
- MASTER UNIT 164
- SLAVE UNIT 164
- Hub/Switch/Router 165
- Simrad MX500 166
- 166 167
- Simrad MX500 168
- Installation notes 169
- Simrad MX500 170
- 170 171
- MX GPS Antenna Installation 172
- MX500 Navigator Installation 174
- 174 175
- Equipment Interfacing 176
- External Alarm Output 177
- Ext. Alarm Relay Conditions 178
- NMEA Interface 179
- MX500 NMEA 0183 Sentences 180
- Data Format 180
- 180 181
- Simrad MX500 182
- Viewing Input Data 183
- Simrad MX500 184
- 184 185
- 186 187
- Simrad MX500 188
- Cross-Over LAN Cable Diagram 188
- Troubleshooting Guide 189
- Memory Backup Battery 190
- Backup Battery Replacement 190
- MX500 PC Interface 191
- Software Update Procedure 192
- Memory Clear Procedure: 193
- Simrad MX500 194
- 194 195
- 5 Specications 196
- Antennas: 197
- Physical 197
- Environmental 198
- Antenna: 198
- MX500 CDU Inputs and Outputs: 199
- Simrad MX500 200
- Appendix A - Datum List 202
- 202 203
- Appendix B - Beacon List 204
- Appendix C - Engineering Mode 222
- 222 223
- Simrad MX500 224
- GPS - GPS CDU Troubleshooting 225
- Simrad MX500 226
- 226 227
- Appendix D - Multiple Unit 228
- Control (Via LAN Connection) 228
- 228 229
- Simrad MX500 230
- Number of MX 500 Units 231
- Simrad MX500 232
- Appendix E - Demonstration 234
- 234 235
- Appendix F - Glossary 236
- 236 237
- Simrad MX500 238
- 238 239
- Simrad MX500 240
- 240 241
- Simrad MX500 242
- 242 243
- Simrad MX500 244
- 244 245
- Simrad MX500 246
- 246 247
- Simrad MX500 248
- 248 249
- Simrad MX500 250
- 250 251
- Simrad MX500 252
- 252 253
- Simrad MX500 254
- 254 255
- How Are We Doing? 257
- Reader Comment Sheet 258
- SIMRAD, A Division of NAVICO 259
- Torrance, CA 90505 259
- REQUEST FOR SERVICE 260
- *500-100-2003* 262
Relacionado con productos y manuales para Navegadores Memorex RX 1 Smart
Navegadores Memorex RX 1 Smart Manual de instalación
(200 paginas)
(200 paginas)
© 2020, manymanuals.es. Todos los derechos reservados | 0.189 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales