Memorex RX 1 Smart Manual de instalación descargar pdf (Pagina 81)

80 | Simrad MX500

When all the waypoint sentences are sent, press 14

the WPT key and scroll through the list to ensure

all the waypoints transferred properly. Go back

to the CFG1/WPT & RTE In option and change

External WPT Input to No.

Uploading Waypoints from a USB Memory

Stick

Waypoints and routes can also be downloaded or upload-

ed using a USB device (i.e. USB flash drive). Please refer

to the CFG1/USB feature of this manual for details.

Mark or MOB

This is a dual function key that either stores your present

position, date and time at the next available waypoint lo-

cation in the Waypoint Bank or when pressed continuous-

ly for 3 seconds, calculates a MOB range and bearing to

a saved spot. A window pops up on the screen to confirm

your key depression, and to tell you where the Mark posi-

tion is being stored. You can go into the WPT menu and

edit the coordinates or description later. This key function

is disabled for 2 seconds after each depression.

The cross-hair symbol to the left of the date in the

Waypoint Bank indicates that the Mark or Event key

created this waypoint. Note that you can also select the

cross-hair symbol from the various symbols for other

waypoints when editing waypoints.

The CDU is also capable of performing this function from

a remote contact closure input via the 8-pin AUX Cable

“MOB/Event” wire. Refer to the Installation Section of this

manual for interface instructions. Contact closure on the

two input pins for 1 second causes a Mark position to be

generated. Contact closure on the two input pins for 3

1 2 ... 76 77 78 79 80 81 82 83 84 85 86 ... 261 262

Sin comentarios

Memorex RX 1 Smart Manual de instalación Pagina 81