Memorex RX 1 Smart Manual de instalación descargar pdf (Pagina 53)

52 | Simrad MX500

You can then choose to enter another waypoint us-7

ing the same method, select Escape to go back one

level and use another method to enter waypoints,

or select Done to go back to the main menu.

Don’t forget to press the 8 EDIT key to end your

editing.

Insert Route

The following example assumes RTE1 is empty. Follow

the directions in the Erasing an Existing Route section to

start with an empty route if you have waypoints in the

RTE1 screen.

To perform this function, you must also have defined a

route in the RTE2 screen. The RTE2 description follows

later in the Route section.

Select the 1 RTE key until the RTE1 screen is dis-

played.

Press the 2 EDIT key to enter the edit mode.

Highlight Insert softkey from the display and press 3

ENT. Skip to the next step if RTE1 is empty.

Highlight 4 Insert Route softkey from the display and

press ENT.

Use the cursor key to scroll through the available 5

dened routes, which are created in the RTE 2

screen, in numerical order.

When you have found the route you want, highlight 6

the Insert Fwd or the Insert Reverse softkey and

press ENT. Insert Fwd enters the route from the

top of the dened list into the active route. Insert

Reverse enters the route from the bottom of the

dened list into the active route so that you can

travel down the route in the reverse direction.

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 261 262

Sin comentarios

Memorex RX 1 Smart Manual de instalación Pagina 53