Memorex RX 1 Smart Manual de instalación descargar pdf (Pagina 114)

112 | Installation

Insert your USB device into the USB port of the MX510.6

Press and hold down the 7 NAV button on the MX510 unit and power ON the unit.

Release the ‘NAV’ key after the unit is powered on.)

MX510 CDU will now bring up the

8 MX510 Software Bootloader.

Please allow a few moments for the

9 MX510 Software Bootloader to detect and

mount your USB device.

After the USB device is successfully mounted, the software bootloader will copy

the program to RAM.

Upon completion of Copying program to RAM, the software bootloader will burn

theprogramtoash.

UponcompletionofBurningprogramtoash,theMX510willjumptotheprogram12

itself (POS2 screen), and software upgrade procedure is completed.

If there’s any problem, please go back to step 1 and try again.

Hint:

It is highly recommended that the MX510 navigator be cold started after downloading

the program. Please note that all settings including waypoints and routes will be lost.

This is important to flush out the residual memory, which may cause problems with the

operation of the unit.

Memory Clear Procedure:

After downloading the software, turn the power off to the MX510 by turning off

the 12 VDC circuit breaker (this may also be accomplished by removing the 12-Pin

Cable from the back of the unit).

Press and hold down the

2 CLR key.

Apply 12-volt power to the unit and wait for about 5 seconds. The MX510 will

come on and display the Northstar logo.

Release the

4 CLR key.

The memory is now cleared.

USB Device Formatting Procedure:

Insert the USB Memory Stick into the USB port of your PC or laptop.

Go to 2 My Computer, right click on your USB device drive (i.e. ‘E:’), and select

“Format...”

Ensure that the 3 File System is set to FAT32. DO NOT check on Quick Format.

Click on the

4 Start button to begin format.

1 2 ... 109 110 111 112 113 114 115 116 117 118 119 ... 199 200

Sin comentarios

Memorex RX 1 Smart Manual de instalación Pagina 114