Memorex RX 1 Smart Manual de instalación descargar pdf (Pagina 54)

52 | Keypad & Display Description

Mark / MOB

This is a dual function key that either stores your present position, date and time at the

next available waypoint location in the Waypoint Bank or when pressed continuously for 3

seconds, calculates a MOB range and bearing to a saved spot (See MOB section on page

58). A window pops up on the screen to confirm your key depression, and to tell you where

the Mark position is being stored. You can go into the WPT menu and edit the coordinates

or description later. This key function is disabled for 2 seconds after each depression.

The cross-hair (⊕) symbol to the left of the date in the Waypoint Bank indicates that the

Mark or Event key created this waypoint. Note that you can also select the cross-hair (⊕)

symbol from the various symbols for other waypoints when editing waypoints.

The CDU is also capable of performing this function from a remote contact closure input

via the AUX Cable “MOB/Event” wire. Refer to the Installation section of this manual for

interface instructions. Contact closure on the two input pins for less than 2 seconds causes

a Mark position to be generated. Contact closure on the two input pins for longer than 2

seconds causes a Man Over Board condition to be generated.

The marker stores the position of the antenna location. Keep this in mind if you are

trying to pinpoint items such as buoys, crab pots, etc. For some special applications such

as these, you may need to locate the antenna at the point on the boat or ship where you

need to make this exact measurement.

GOTO

Using the GOTO function key is the fastest way to create a single leg route. This method

will cause the existing active route to be erased and overwritten with the new position you

define.

From any screen press the

1 GOTO key.

Press the

2 EDIT key.

Select the waypoint determination method you want:3

Waypoint Number - allows you to choose a waypoint stored in the Waypoint Bank,

where you enter the waypoint number.

Choose in Bank - as used in the Route function (refer to Route - Choose In Bank

section of the manual), allows you to view waypoints in the Waypoint Bank as

a list.

Lat. Lon., UTM- allows you to define a coordinate and description, which is also

stored at the next available waypoint location in the Waypoint Bank.

Bearing Range - allows you to define a coordinate by specifying the bearing and

range from your present position, which is also stored at the next available

waypoint location in the Waypoint Bank.

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 199 200

Sin comentarios

Memorex RX 1 Smart Manual de instalación Pagina 54