Memorex RX 1 Smart Manual de instalación descargar pdf (Pagina 93)

Keypad & Display Description | 91

Here is a sample of the Brief format with an active route or MOB condition:

MX510 Navigator

====================================

21:24:00 UTC 11 Aug 1997

POS Mode : DGPS 3D Datum:W84

POS: N 33 48.5124 W 118 21.0213

COG: 152T SOG: 0.1 Kn

BRG: 239T Dist: 27.4 Nm XTE:0.14L Nm

RTE: RL From WPT 1234 To WPT 1357

-------------------------------------------------------------------------

Sending: Causes the printer output to be turned On or Off (default).

Print Interval (Sec): Allows you to control how often the print out will be sent to the

printer port. The default value is 60 seconds, and the valid range is from 1 to 9999

seconds.

Format: Allows you to choose either the Full or Brief formats described above.

Bit Rate: This allows you to control the port interface baud rate to match the printer or

computer you are interfacing with. The available baud rates are: 600, 1200, 2400,

4800 (default), 9600 or 19,200.

Data Bits: This allows you to match the printer’s requirement of 7 or 8 (default) bit serial

data.

Stop Bits: This allows you to match the printer’s requirement of 1 (default) or 2 stop bits.

Parity Check: This allows you to match the printer’s requirement of None (default), Even

or Odd parity.

Handshake: This allows you to match the printer’s requirement of No (default), XON/

XOFF or HW (Hardware; CTS, RTS ).

ROT (Rate of Turn)

The ROT configuration menu is available in the MX51x model. The “ROT connected”

mode can be toggled to YES or NO, by pressing the EDIT key and then highlighting the

‘Change’ softkey and press ENT.

Data input port no: 2 (valid port selections are 1,2, or 3*)

Alarm if no data: .. No (‘Yes’ value sets the alarm to sound if no ROT input data is

detected in 5 seconds)

*Use MX575 ROT: No

(‘Yes’ value would allow the MX51x to use ROT data from Port 3

when the MX575 is used as a positiong and heading device. ‘No’

value would allow the MX51x to use ROT data from any available

port other than Port 3 when the MX575 is used as a heading

device only (See MX575 Satellite Compass Installation and

Operation Manual for details).

1 2 ... 88 89 90 91 92 93 94 95 96 97 98 ... 199 200

Sin comentarios

Memorex RX 1 Smart Manual de instalación Pagina 93