Memorex RX 1 Smart Manual de instalación descargar pdf (Pagina 24)

22 | Keypad & Display Description

FUNCTION Keys

You might have noticed that above and below each primary function key are numbers

and letters. These numbers and letters are used when you are in the edit mode. You will

find that they are most often used in the RTE, WPT, and CFG screens, but they are used

in other screens as well. If you are trying to enter text, simply locate the desired letter

and press the appropriate function key repeatedly until the appropriate letter or number

appears. If you accidentally go past the desired letter, repeat pressing the function

key and the letter will come up again. You can toggle between upper and lower case

characters by pressing the function key for a long period.

You will also find that some screens allow you to input symbols into the text fields. These

symbols are selected through a softkey selection where symbols are allowed. Don’t

forget to press the ‘EDIT’ key to get out of the edit mode.

Another helpful feature on this CDU is that successive depressions on the function key

(when not in the edit mode) allows you to page through all of the screens available for

that particular function. You can accomplish the same thing by selecting a function

and using the left and right arrows on the cursor key (which is sometimes faster). In

addition, the software remembers which screen you used last for each function. Each

time you reenter a function (e.g. you go from PLOT to NAV), you will enter the last

screen you viewed for that function. You can change this setting in the CFG 1 Operation.

Use the associated function key to access the international character desired (i.e. A for

Æ). The international characters supported are:

ABC = Ä, Å, Æ, À, Ç

DEF = É, È

GHI = Í

MNO = Ñ, Ó, Ö

STU = Ú, Ü

Use the CFG key when in the edit mode to cycle through these other optional characters.

‘ “ $ & ! ( ) ? / + - ° . , :

Automatic Identication System (AIS)

This is a special function key used for diplaying AIS related data. TThe AIS feature is a

licensed option in the MX512 model. Contact your dealer or NAVICO to purchase the

AIS license.

When this key is pressed, the message “AIS Not Available on this Version” will be

displayed.

Navigate

There are six NAV screens. NAV1 through NAV3 are primary navigation screens. NAV4,

NAV5, and NAV6 only provides data if appropriate sensors (e.g. wind speed/direction

logs, NMEA compass, etc.) are interfaced and activated on the CDU. The NAV functions

are highly interactive with the RTE1 screen, and a number of CFG menu selections.

The RTE1 screen provides the active route for the NAV screens. It also maintains a

waypoint pass log for you. One other important feature in the RTE1 screen that you

need to be aware of is that the up and down arrow softkeys control which waypoints are

skipped (down arrow) and which are restored (up arrow) for your current route. The ETA

information is configured in the RTE 1 screen. Refer to the Route section of the manual

for a full description.

The following CFG menus directly impact the NAV functions:

COG SOG - sets the filtering time for the displayed values.

•

Datum - sets the reference datum for your present position and waypoints in the

•

active route. WGS84 is the preferred Datum for most navigation calculation including

AIS.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 199 200

Memorex RX 1 Smart Manual de instalación Pagina 24

Comentarios a estos manuales